ASV SR-70 Service Manual download pdf (Page 93)

17. Apply red (high strength) thread locking compound

to the wheel retaining bolt as shown. (fig. 13-26)

18. Install the bolt and tighten it. (fig. 13-27)

19. If you haven’t already, repeat steps 10-18 of this

procedure on the other side of the hub/wheel

assembly to secure the second wheel in place.

20. Once the hub/wheel assembly is together as

shown, torque the wheel retaining bolts to 180 ft.

lbs. / 244 Nm to secure them in place. (fig. 13-28)

21. Remove the allen plug from the center of the hub

assembly and fill it with 2 ounces of Terex 10W-30

Heavy Duty Engine Oil. Then reinstall the plug.

(fig. 13-29, 13-30)

22. Repeat this procedure on the other half of the

bogie assembly if necessary prior to installing the

two halves back onto the undercarriage.

23. Place the rubber rods back into position on the

square shaft, then tape them in place to keep

them secure while installing the bogie assemblies

around them. (fig. 13-31)

24. Reverse steps 1-3 of this procedure to reinstall the

bogie assembly back onto the undercarriage and

complete the procedure.

25. Repeat this procedure as necessary throughout

the PT-80 undercarriage to restore proper function.

13-7

Rubber Track Loader

13. Undercarriage

13-26

13-28

13-29

13-27

13-30

13-31

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 140 141

No comments

ASV SR-70 Service Manual Page 93